Use the MODEīutton to change/advance the number, and the ST./STOP(S) Button to switch between “HOURS” and “MINUTES”.ģ. This is an indication that you are in theĢ. In the TIME Function(Tm), hold down the MODE Button, the In K (kilometers), a 24-HOUR CLOCK is selected, while in M (miles), a 12-HOUR CLOCK is selected. The CLOCK is set to either 24- HOUR or 12-HOUR depending on the SPEED SCALE selected. PendingĬCMED2N-011119 Printed in Japan 066600090 aįor setting the CLOCK, the TIME function must be turned off and the speed scale symbol (either M for Miles or K for Kilometers) must not be flashing (Fig. Hesive tape, to the inside of the right front fork. If not, re-adjust the position of the sensorĪttach the sensor and the magnet properly so that their positions meet the following conditions The front wheel and see if the speed appears in the display. To re- move, slide it forward while pushing the lever. Slide the main unit until it clicks into position. Sure you can turn the handlebars all the way from side to side with- out pulling the wire. Secure the wire along the fork with the nylon ties Paint thinner, benzine, alcohol or other chemicals may damage the surface. To clean the computer, use mild soap and a soft cloth.Do not leave the main unit exposed to direct sunlight.Used batteries must be disposed of properly and in accor.All manuals on can be viewed completely free of charge. View a manual of the Cateye Enduro 8 CC-ED300 below. View manual Ask a question Cateye Enduro 8 CC-ED300 manual. On your bicycle, and periodically check to insure they are mounted securely. User manual for the Cateye Enduro 8 CC-ED300 in English. Be sure to securely mount the magnet, sensor and bracket.Do not concentrate too much on the computer operations.Set the number by pressing the SET Button. You can fast forward the num- bers by holding either buttons down. Enduro 2 Bicycle Accessories manuals and instructions online. Press the START/STOP(S) Button to decrease it. Cateye Enduro 2 User Manual View and Read online. Press the MODE Button to increase the num- ber. The number “210” (typical wheel circum- ference for 700x23C tires) will be dis- played (Fig. Then press the START/STOP(S) Button to set the scale. A press on the MODE Button will display “K” and “M” alternately (Fig. The entire memory of the computer will be erased, and the complete screen will light up and then all fade away, leav- ing a flashing “K” on the screen. Press the SET Button while pressing the MODE and START/STOP(S) Buttons (ALL CLEAR OP- ERATION: Fig. TION to clear the computer and set the speed scale: This distance in centimeters is the most accurate number. In this method, properly inflate the tires, sit on the bike and measure the distance of one wheel length. Alter- nately, you can find the most accurate wheel cali- bration number by rolling the tire on the ground. The following set up is required before use:ĭetermine the length of the tire (Length in centi- meters) from the Cross Reference Table. The section “Manually Replacing Mileage into Odometer” described in the last section of this manual. NOTE: To utilize previously accumulated Odometer data, refer to The speed sensor, handlebar bracket and wheel magnet should be installed first.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |